Safety; International Safety Symbols; Safety Notes; Warnings - koban KPAW-01A Manual Del Usuario

KPAW-01A

1. Safety

1-1. International Safety Symbols

This symbol, adjacent to another symbol or terminal, indicates the user must
refer to the manual for further information.
This symbol, adjacent to a terminal, indicates that, under normal use,
hazardous voltages may be present.
Double insulation

1-2. Safety Notes

• Do not exceed the maximum allowable input range of any function.
• Do not apply voltage to meter when resistance function is selected.
• Set the function switch OFF when the meter is not in use.
• Remove the battery if meter is to be stored for longer than 60 days.

1-3. Warnings

• Set function switch to the appropriate position before measuring.
• When measuring volts do not switch to current/resistance modes.
• Do not measure current on a circuit whose voltage exceeds 600V.
• When changing ranges always disconnect the test leads from the circuit under test.

1-4. Cautions

• Improper use of this meter can cause damage, shock, injury or death. Read and
understand this user manual before operating the meter.
• Always remove the test leads before replacing the battery or fuses.
• Inspect the condition of the test leads and the meter itself for any damage before
operating the meter. Repair or replace any damage before use.
• Use great care when making measurements if the voltages are greater than 25VAC rms
or 35VDC. These voltages are considered a shock hazard.
• Always discharge capacitors and remove power from the device under test before
performing Diode, Resistance or Continuity tests.
• Voltage checks on electrical outlets can be difficult and misleading because of the
uncertainty of connection to the recessed electrical contacts. Other means should be
used to ensure that the terminals are not "live".
• If the equipment is used in a manner not specified by the manufacturer, the protection
provided by the equipment may be impaired.
2
EN EN
Function
A AC, A DC
V DC, V AC
Resistance, Capacitance, Frequency, Diode Test
Temperature

2. Description

2-1. Meter Description

1. Current clamp
2. Flash light LED
3. Non-contact AC
3. voltage indicator light
4. Flash light button
5. Clamp trigger
6. Rotary Function swith
7. Data Hold and Backlight button
8. MODE select button
9. PEAK and INRUSH button
10. Max/Min button
11. RAGNG button
12. LCD display
13. COM input jack
14. V Ω CAP TEMP Hz jack
15. Battery Cover
KPAW-01A
Maximum Input
1000A AC
1000V DC/AC
600V DC/AC
600V DC/ AC
1
CAT IV I MAX
600V 1000A
2
Non–Contact
Voltage–Delector
3
OFF
4
5
6
w
7 13
AUTO
OFF
POWER OFF
9
8
RAGNG
10
11
12
AC/DC TRMS H&W ANALYSIS CLAMP METER
V W Ω Hz CAP
COM
Hz% Temp
13 14
15
3