Dimplex Revillusion RBF30 Manual Del Propietário página 18

Operation
Icon Function
Power/
A
Standby
B
Heat
C
Temp Down
D
Temp Up
Change Fahrenheit
( F) to Celsius (
°
Heat Enable
Heat Disable
18
Description
Press to activate the current standby state (On/Off).
• Standby State On
Press to turn everything Off. Press again to activate
the previous state.
• Standby State Off
Press to activate the previous state.
- If the flame effect was On, the previous heat setting
will be activated (On or Off).
- If the flame effect was Off, the previous heat setting
will be activated (High or Low).
Press again to turn everything Off.
• Heat On
Press to turn heat On (indicated by 1 short beep and
the icon appearing on the display). Displays current
heater temperature setting. Use the Temp Up/Down
icon to change the heater temperature setting.
• Heat Off
Press to turn heat Off (indicated by 1 short beep).
!
NOTE: After the heater is switched off, the fan will
continue on for 60 seconds before turning off.
Press multiple times to lower the heater temperature
in 1 F (1
°
lowest temperature is 41
active whenever the heat is enabled.
Press multiple time to raise the heater temperature in
1 F (1
°
highest temperature is 99
active whenever the heat is enabled.
Press both Temp+ (
C)
°
panel controls.
Hold both Heat (
panel controls for 2 seconds. Temperature displays on
the screen.
Hold both Heat (
panel controls for 2 seconds, when temperature is
adjusted "---" displays on the screen.
°
C) increments. Displays current temperature;
°
C) increments. Displays current temperature;
°
) and Temp– (
) and Temp– (
F (5 C). This feature is
° °
F (37 C). This feature is
° °
) and Temp– (
) on the touch
) on the touch
) on the touch
www.dimplex.com