Using Extension Cords - Hilti TE 30 Manual Del Usuario

transformer or generator must always be within +5 % and -15 % of the rated
voltage of the device.
Weight
Ø hammer drill bits
Ø hammer drill bits
Ø drill bits for wood
Ø drill bits for wood
Ø drill bits for metal
Ø drill bits for metal
5

Using extension cords

WARNING
A damaged supply cord presents a hazard! Do not touch the supply cord
or extension cord if damaged while working. Disconnect the supply cord
plug from the power outlet.
▶ Check the appliance's supply cord at regular intervals and have it
replaced by a qualified specialist if found to be damaged.
• Use only extension cords of a type approved for the application and
with conductors of adequate gauge (cross section). The power tool
may otherwise suffer a drop in performance and the extension cord may
overheat.
• Check the extension cord for damage at regular intervals.
• Replace damaged extension cords.
• When working outdoors, use only extension cords that are approved and
correspondingly marked for this application.
Recommended minimum conductor gauge (cross section) and maxi-
mum cord length with 120V supply voltage
Extension cords
Extension cord conductor
gauge
Extension cord conductor
gauge
Extension cord length
Extension cord length
8 English
TE 30
9.0 lb
(4.1 kg)
1/4 in ... 1 1/8 in
6 mm ... 28 mm
3/16 in ... 1 in
3 mm ... 25 mm
3/16 in ... 1/2 in
3 mm ... 13 mm
AWG 16 AWG 14
1,31 2,08
mm² mm²
2,58 4,11
kcmil kcmil
25 m 30 m
75 ft 100 ft
2143374
TE 30­AVR
9.3 lb
(4.2 kg)
1/4 in ... 1 1/8 in
6 mm ... 28 mm
3/16 in ... 1 in
3 mm ... 25 mm
3/16 in ... 1/2 in
3 mm ... 13 mm
AWG 12 AWG 10
3,31 5,26
mm² mm²
6,53 10,4
kcmil kcmil
50 m 100 m
150 ft 250 ft
*2143374*