Troubleshooting; Technical Data; Limited Warranty - GreenWorks MO09B01 Manual Del Operador

EN
• Replace the damaged parts.
• Tighten the bolts.
• Speak to a person of an approved service center.
• Store the machine in a dry area.
• Make sure that children cannot come near the machine.
You may lower the handle(s) before you put the machine into
the storage.
1. Fully loosen the handle fasteners on the sides of the
handle(s).
2. Fold away the handle(s).
3. Do not pinch or trap the cables.
10

TROUBLESHOOTING

Problem
The handle is not
in position.
The machine does
not start.
The machine cuts
grass unevenly.
The machine does
not mulch correct-
ly.
The machine is
hard to push.
Possible cause Solution
The bolts are not Adjust the height
engaged correctly. of the handle and
make sure that the
knobs and bolts
are aligned cor-
rectly.
The extension ca- Reconnect the ca-
ble is not connec- ble.
ted to the outlet.
The extension ca- Connect the exten-
ble is not connec- sion cable to a live
ted to the power 120V AC, 60 HZ
supply. AC receptacle.
The handle switch Replace the handle
is defective. switch.
The lawn is rough. Examine the mow-
ing area.
The blade height is Move the wheels
not set correctly. to a higher posi-
tion.
Wet grass clip- Wait until the
pings attach to the grass dries before
deck. mowing.
The grass is too Increase the blade
tall, or the blade height.
height is too low.
The grass catcher Empty the grass
and the blade clippings from the
drags in thick grass catcher.
grass.
English
Problem
There is a high vi-
bration in the ma-
chine.
The machine stops
during mowing.
* If you cannot find the solution to these problems, go to the
service center.
11

TECHNICAL DATA

Motor
No load speed
Cutting deck width
Height adjustments
Functions
Weight
Double-insulated con-
struction
12

LIMITED WARRANTY

Greenworks hereby warranties this product, to the original
purchaser with proof of purchase, for a period of three (3)
years against defects in materials, parts or workmanship.
Greenworks, at its own discretion will repair or replace any
12
Possible cause Solution
The blade is un- Replace the blade.
balanced and
worn.
The motor shaft is 1. Stop the ma-
bent. chine.
2. Disconnect the
power supply.
3. Inspect for
damage.
4. Repair the ma-
chine before
you start it
again.
The blade height is Increase the blade
too low. height.
The grass clip- Disconnect the
pings attach to the power supply and
deck or the blade. check the deck.
Operation temper- Cool the machine.
ature of the ma-
chine is too high.
120 V AC, 60 Hz, 9 A
3500 RPM
14"(35cm)
1 1/8 - 3 1/8" (2.8 - 8 cm)
2-in-1 Mulching / Rear bag
12.8 kg (28.2 lbs.)
3
YEAR
ANS
AÑOS
LIMITED WARRANTY
GARANTIE LIMITÉE
GARANTÍA
LIMITADA