Troubleshooting - GreenWorks MO12B00 El Manual Del Propietario

TROUBLESHOOTING

PROBLEM
The handle is not in
position.
The mower does not start.
The mower cuts the grass
unevenly.
The mower is not mulching
properly.
The mower is hard to
push.
The mower vibrates at
higher speed.
POSSIBLE CAUSE
Carriage bolts are not seated
properly.
Cam handle is not tightened.
The extension cord is not
connected to the mower plug.
The extension cord is not
connected to the power source.
The control switch is defective.
The lawn is rough or uneven.
The cutting height is not set
properly.
Wet grass clippings are sticking
to the underside of the deck.
The grass is long, or the cutting
height is too low.
The rear of the mower housing
and the blade are dragging in
heavy grass.
The motor shaft is bent.
The blade is unbalanced.
25
SOLUTION
Adjust the height of the handle and
make sure the carriage bolts are
seated properly.
Tighten cam handle.
Reconnect the cord, and use the
cord restraint to keep the cord close
to the switch.
Connect the extension cord to a live
120V AC, 60 HZ AC receptacle.
Have motor control switch replaced
by an authorized service center.
Check the mowing area.
Move the wheels to a higher
position.
Wait until the grass dries before
mowing.
Raise the cutting height.
Stop the motor, disconnect the
mower from the power source,
and inspect it for damage. Repair
the mower before restarting. If the
vibration persists, call the toll-free
helpline, at 1-888-909-6757.
Balance the blade by grinding each
cutting edge equally.