Stalgast KGPG-4 Serie Manual De Instrucciones página 44

•
For the sake of rational energy consumption and proper combustion, it is advisable to use pots of an
appropriate diameter in relation to the heat load of the burner:
- for the 9kW burner, use of pots with diameters from 42 cm and higher is recommended
- for the 7kW burner, use of pots with diameters from 38 cm to 46 cm is recommended
- for the 5kW burner, using pots with diameters from 32 cm to 38 cm is recommended
- for 3.5kW burner, using pots with diameters from 28 cm to 32 cm is recommended
The bottom should
be suitably larger for
this burner
•
Do not use any dishes other than those intended for warming up. Use of inappropriate dishes (e.g.
plastic ones) may result in fire hazards.
•
Make sure that all the knobs of the unused burners are in the „closed burner" position (Fig.10). pilot
knobs of stove burners are placed on the right side of the control panel (Fig.1, item 5).
Figure 10. Setting a knob in the position, in which the gas supply to the burner is completely
•
Open the valve for LPG cylinders equipped with the LPG reductant (only for LPG-powered stoves).
•
Press the control knob of the selected burner while holding the lit match or the lighting appliance (e.g.
electric lighter) in your hand.
•
Turn the knob to the „pilot burner" position as shown in Fig. 11 (counterclockwise)
Figure 11. Setting the knob when only the pilot burner is gas-powered.
•
Ignite the gas via the „pilot burner" with the previously prepared match or lighting appliance, and press
and hold the knob for about 20 seconds (the time it takes for the protection to come into effect)
Concave bottom
cut off.
- 44 -
Bottom too small for this
burner