Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Warranty (cont.)
5. It is recommended that the consumer save the invoice or receipt as additional protection, as it may
substitute the warranty in the case that there is a discrepancy in the validity of the warranty.
EXCEPTIONS AND RESTRICTIONS
The Warranty will not be valid in the following cases:
1. When the product is not operated in accordance with the instructions concerning use and operation set
forth in the owner's manual or installation instructions, and when the recommendations and warnings
included are not observed.
2. When the product has been modified or dismantled partially or totally; or has been used in a negligent
fashion and as a consequence has suffered damages attributable to the consumer, individual, or hardware not
authorized by Kohler Co.
3. This warranty does not cover the damages as a result of disaster such as fire or acts of God, including
flooding, earthquake, or electric storms, etc. To obtain a list of distributors in your area where you can
exercise your rights under this warranty, please call 001-800-456-4537.
KOHLER CO., KOHLER, WI 53044 U.S.A.
IMPORTER:
INTERNACIONAL DE CERÁMICA, S.A.B. DE C.V.
AV. CARLOS PACHECO NO. 7200
CHIHUAHUA, CHIH., MEXICO C.P. 31060
TEL: 52 (14) 29-11-11
Troubleshooting
NOTICE: This section is for general aid only. A Kohler Co. Authorized Service Representative or
qualified electrician should correct any electrical problems. For warranty service, call 1-800-4KOHLER
from within the USA and Canada, or 001-800-456-4537 from within Mexico.
For service parts information, visit your product page at www.kohler.com/serviceparts.
Symptoms
1.
Blower turns on by itself
after the bath has been
drained.
2.
Blower turns off by itself
after running for two
minutes.
3. Blower motor will not
start.
4. Blower motor stops
running and will not
immediately restart.
Kohler Co.
Probable Causes
A. Normal operation. Automatic
purge mode is working as
designed.
A. The Purge Mode icon was
pressed instead of the On/Off
icon.
A. Power cord from blower motor
is loose, disconnected, or
damaged.
B. User keypad cable loose or
damaged.
C. User keypad does not work.
D. Blower motor does not work.
A. Blower motor overheated and
protection device activated.
13
Recommended Action
A. No action is required. Automatic
purge mode runs for two minutes
30 minutes after the bath is
drained.
A. Press the On/Off icon on the
keypad. See the "Operating
Instructions" section.
A. Check wiring for proper
connections.
B. Check wire connections. If
necessary, replace user keypad
cable.
C. Replace user keypad.
D. Replace the blower motor.
A. Check for blockage at blower air
intake. Remove blockage and allow
motor to cool.
1198326-2-A
Tabla de contenido
