TOYAMA TDWE 8 Guia Del Propietario página 13

(6) - Refit the injection pump and tighten the set screws. In doing so, special care must be taken
with the piston adjusting arm ball which must be engaged in the slot on the speed control fork
inside the gear case. This should be checked again through the inspection hole after mounting
the pump again to avoid the "deviation" of the motor resulting from a possible wrong assembly.
After adjustment, it is recommended to check again according to item 3 above. Resetting
is necessary if something is incorrect.
Decompression Device Adjustment
The proper operation of the pressure relief device can be tested by hand feeling as follows: Turn
the pressure relief lever clockwise with your left hand, and at the same time, start the engine with
your right hand using the starting crank. If your left hand becomes heavy while your right hand is
light, then the pressure relief device is working properly. However, pay attention so that the
pressure relief shaft does not touch the rocker while the engine is running, after releasing the
decompression lever.
If this is the case, adjust as follows:
1. Loose the locking nut..
2. Rotate the eccentric bushing through an angle to make the adjustment. Turn clockwise
if decompression is too low, turn counterclockwise if decompression is too high. (Fig. 13).
13