Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Figure D
Adjustments, Final Assembly, and Maintenance
Doors
The cabinet doors have a three-way adjustment feature.
Height, level, and fi t-to-frame can all be adjusted using a
#2 Phillips Head screwdriver.
■
HEIGHT: If the door is too high or low, adjust the door
down or up with screw #2 as shown in Figure E. This
screw is located inside the hinge and requires the door to
be opened approximately 90° to access the screw.
■
LEVEL: If the door is out of level or too close to one
side, adjust the door to the left or right using screw #1 as
shown in Figure E.
■
FIT-TO-FRAME: If the door opens stiffl y, squeaks, or
rubs against the gasket, adjust the door outwards with
screw #3 as shown in Figure E.
HINGE
1 2
DOOR
ADJUST DOOR PITCH
SIDE-TO-SIDE
USING SCREW #1
Figure E
MOUNT/UNMOUNT
OR ADJUST DOOR
FORWARD OR
BACKWARD
USING SCREW #3
3
ADJUST DOOR
UP/ DOWN
USING SCREW #2
Circuit Breaker
Panel
20A GFI
Breaker
TERMINAL
BLOCK
BLACK
BLACK
WHITE
WHITE
GROUND
Installing Shelves
1. Insert clear snap-in Shelf Clips into
the holes on the sides of the cabinet.
See Figure F.
2. Push one side of the shelf into the left or right clip (A).
3. Snap the shelf down into the opposite side (B). If the
shelf is too tight, repeat the process starting from the
opposite side.
209-1073 FAIRHAVEN Full Length Recess Mounted Cabinet
3
NOTE:
Use Copper Wire Only.
NOTE:
Tighten terminal block screws
to 7 in-lbs. ( 0.7904 N·m)
GREEN
A
ı
B
ˇ
Figure F
Tabla de contenido
