Items Supplied; Technical Data - Hilti SF BT 22­A Manual De Instrucciones

Status
1 LED blinks, the power tool is not ready for use.
4 LEDs blink, the power tool is not ready for use.
Note
Battery charge status cannot be displayed while the control switch is pressed and for up to 5 seconds
after releasing the control switch.
If the battery display LEDs blink, please observe the instructions given in the Troubleshooting section.

3.6 Items supplied

Electric drill, operating instructions.
Note
You can find other system products approved for your product at your local Hilti Center or online at:
www.hilti.com.

4 Technical data

4.1 Drill
Rated voltage
Weight in accordance with EPTA procedure 01/2003
Torque
Keyless chuck clamping range
4.2 Noise information and vibration values determined in accordance with EN 60745
The sound pressure and vibration values given in these instructions have been measured in accordance with
a standardized test and may be used to compare one electric tool with another. They may be used for a
preliminary assessment of exposure.
The data given represents the main applications of the electric tool. However, if the electric tool is used for
different applications, with different accessory tools, or is poorly maintained, the data may vary. This may
significantly increase exposure over the total working period.
An accurate estimation of exposure should also take into account the times when the power tool is switched
off, or when it is running but not actually being used for a job. This may significantly reduce exposure over
the total working period.
Identify additional safety measures to protect the operator from the effects of noise and/or vibration, for
example: maintaining the power tool and accessory tools, keeping the hands warm, organization of work
patterns.
Noise emission values determined in accordance with EN 60745
Emission sound pressure level (L
Uncertainty for the sound pressure level (K
Sound (power) level (L
WA
Uncertainty for the sound power level (K
Total vibration (vector sum of three directions), measured in accordance with EN 60745
Vibration emission value for drilling in metal (a
Uncertainty for drilling in metal (K)
14 English
Printed: 19.10.2016 | Doc-Nr: PUB / 5252274 / 000 / 01
)
pA
)
pA
)
)
WA
h, D
Meaning
• The battery has overheated or is completely
discharged.
• The power tool is overloaded or has overheated.
21.6 V
1.9 kg
≤ 9 Nm
1 mm ... 10 mm
SF BT 22­A
71 dB(A)
3 dB(A)
82 dB(A)
3 dB(A)
SF BT 22­A
) 3.5 m/s²
1.5 m/s²