La-Z-Boy PowerReclineXR+ Manual Del Usuario página 7

PowerReclineXRw +
ssembly Instructions
4. Adjust the glides to ensure a height that provides a clear path for operation of the legrest. Each glide is
attached to the base rail by one jam nut and one lock washer on top of the base rail, and one jam nut
on the bottom of the base rail.
To extend the glide, loosen the upper jam nut by rotating clockwise. Turn the lower jam nut
•
clockwise to the desired height.
Tighten the upper jam nut by rotating counterclockwise.
•
Repeat steps one and two for each adjustable glide on the unit, if needed.
•
Repeat this procedure, as necessary, to adjust the front height of the unit and level it.
•
Upper Jam Nut
Lock
Washer
Base Rail
5. Locate the motor connector, one behind each reclining seat (F
console, a Y-cable is used to join the two motor connectors; all other sofas connect directly to the
power supply.
For a reclining loveseat with console, align one motor connector to a long lead Y-cable connector,
•
push the connectors together until seated and close the locking cover to secure the connection
(F 8). Repeat this for the other motor connector and Y-cable long lead. Then align the short
IGURE
lead of the Y-cable to the power supply connector, push the connectors together until seated and
close the locking cover to secure the connection (F
For all other sofas, connect one power supply to each motor connector. Align the motor connector
•
to the power supply connector, push the connectors together until seated and close the locking
cover to secure the connection (F
IGURE
6. Connect the 120 volt power cord to the power supply (F
push together until seated. Do this for each power supply and 120 volt power cord included with the
furniture. Do not plug in until instructed in the Operating Instructions.
7. Proceed to the Battery Backup Assembly Instructions.
To Remove a Back:
1. Unplug the 120 volt power cord from the electrical outlet and disconnect the power supply from
either the Y-cable or motor connector, whichever comes with the product.
2. Taking care not to damage the cover, insert a screwdriver between the arm and back and engage
the locking lever on the back bracket (F
3. Push up on the locking lever until the lever is at 45 to 30 degrees from vertical (F
4. Repeat steps 2 and 3 for the other side of the back, inserting the screwdriver between
the rear post and back.
5. The back is free to remove at this point. Lift up on the back to remove.
6. Repeat steps 2 – 5 for each back.
12
Motion Sofa
TM
Lower Jam Nut
Adjustable Glide
7). For a reclining loveseat with
IGURE
9).
IGURE
10).
11). Align the connector ends and
IGURE
12).
IGURE
IGURE
F 7
IGURE
F 9
IGURE
Make this
connection
Y-Cable Short Lead
F 11
IGURE
Make this
connection
12).
120 Volt
Power Cord
PowerReclineXRw +
Motion Sofa
TM
ssembly Instructions
F
IGURE
Motor Connector
F
IGURE
Make this
connection
Power Supply
Power Supply*
*Power supplies/connections may
vary by date of manufacture.
F
IGURE
Back
Bracket
Power
Supply
8
Make these
connections
Y-Cable Long Leads
10
Motor Connector
12
45 Degrees
from
Vertical
Locking
Lever
13