La-Z-Boy PowerReclineXR+ Manual Del Usuario página 6

PowerReclineXRw +
ssembly Instructions
NOTICE:
-- Do not plug in until instructed.
1. Remove all packaging from the unit and locate the boxed power supply, electrical
components bag and bubble wrapped hand wand secured to the body bracket of the unit (F
There is one each per reclining seat, except with a reclining loveseat with console.
2. Carefully cut the plastic tie(s) securing the parts and move them away from the bracket. Remove
the bubble wrap from the hand wand and lay hand wand on the seat (F
• Remove the power supply from the box and set aside; do this for each power supply received.
Remove the cords from the electrical components bag and set aside. The reclining loveseat with
•
console includes a Y-cable and a 120 volt power cord, while all other reclining sofas include two
120 volt power cords, one for each power supply.
WARNING
– To reduce the risk of injury:
• Do not operate the unit until the back is installed and locked.
3. Install the back.
Lay the backs face down on the seats. Starting with one back, turn the locking levers, located
•
on the brackets attached to the back (one on each side), 45 to 30 degrees from vertical (F
• Hold the back at a slight angle to the seat and align the brackets on the back with the brackets
on the body (F 4).
IGURE
Rotate the back upright and lower the back onto the body (F
•
body brackets are completely engaged.
To make sure the back is properly installed with both sets of back and body brackets
-
engaged, stand behind the unit and twist the back from side to side. If one or both sides
move out of position the brackets are not engaged (F
repeat the steps above.
- If you are unable to install the back properly, contact your La-Z-Boy
Lock both back brackets by using a screwdriver to push the locking levers down (F
•
Repeat this step for each back.
•
(Assembly Instructions Continued)
10
Motion Sofa
TM
IGURE
2).
IGURE
3).
IGURE
4), making sure the back and
IGURE
5). Remove the back and
IGURE
® dealer for assistance.
6).
IGURE
PowerReclineXRw +
F 1
IGURE
1).
Hand Plastic
Wand Tie
F 3
IGURE
Back
Bracket
F 5
IGURE
Back and body brackets on this side are not
engaged. Remove the back and reinstall.
Motion Sofa
TM
ssembly Instructions
F 2
IGURE
Power Supply & Hand
120 Volt Power Cord Wand
F 4
IGURE
45 Degrees
from
Vertical
Locking
Lever
Body Bracket
Back Bracket
F 6
IGURE
Back
Bracket
Locking
Lever
at 45
Degrees
from
Vertical
Locked
Position
11