Filter Installation And Maintenance - Shop-Vac BP Serie Manual Del Usuario

SET UP AND OPERATION (CONT'D)
ACCESSORIES, HOSES AND WANDS
Not all vacs include all accessories shown.
Nozzles and Accessories
Lock
Carpet
Tool
Insert
Floor
Brush
Insert
14" (35.56cm) ABS Plastic
Master Nozzle
Inserts lock into place by
sliding red buttons. Elbow swivels.
Carpet
Tool
Insert
Squeegee
Insert
Deluxe 12" (30.48cm) Nozzle
Inserts snap-in and out.
Elbow swivels.

FILTER INSTALLATION AND MAINTENANCE

FILTRATION SYSTEM
There are a variety of filters available for your vacuum. It is important to have the correct filters installed for
your cleaning operation to protect your vacuum motor.
NOTE: When using the vacuum to pick up very fine dust. It will be necessary to empty the tank and clean
the cage filter at more frequent intervals to maintain maximum pick up power or add a disposable filter bag.
NOTE: Never use the vacuum for dry pick up without a dry use filter installed.
WARNING
BEFORE REMOVING THE TANK COVER.
Follow the instructions for the filter that came with your vacuum. Some filters mentioned do not come
standard with all vacuums. Additional filters are available at your local dealer or the Shop-Vac
CARTRIDGE FILTER
(Not standard with all models)
When picking up fine dust or powders a high efficiency filter bag must be used with the cartridge filter.
1. Use the cartridge filter in position inside lower filter housing for most general dry
material pick up.
2. With cord disconnected from receptacle, remove filter cover from lower housing.
Filter cover is not needed when using the cartridge filter. Do not discard.
Lock
All Friction Fit
Accessories
Insert wand end or hose
Double
Blade
into accessory and twist to
Squeegee
form a tight fit.
Insert
14" (35.56cm) Metal
Master Nozzle
Inserts lock into place by
sliding insert onto nozzle.
Dual Surface Selector Nozzle
Levers control brush position for
various types of cleaning.
–
ALWAYS DISCONNECT THE PLUG FROM THE WALL OUTLET
(1.25" (3.18cm)
utility nozzle
shown)
Brush Insert Shown
Wands
All Friction Fit Wands
Insert wand ends together
and twist to form a tight fit.
Positive Locking Wands
Insert wand ends together
until metal push button locks.
Locking Nut Wand End
Insert wand end over nozzle
and tighten nut.
website.
®
FILTER
COVER
PAGE 9