Battery / Charger Safety; Battery Disposal - Dremel 800 Manual De Instrucciones

6971 Dremel Manual 800 11.11.2003 18:03 Uhr Seite 12
• Before using accessories always compare the
maximum allowed r.p.m. of that specific accessory
with the r.p.m. of the tool
• This tool should not be used by people under
the age of 16 years
• Never use grinding wheels over 1 1/4" (32 mm) Ø
• Never use drill bits over 1/8" (3.2 mm) Ø
• Never use shaft lock while tool is running
• Store tool in locations where temperature will
not exceed 40°C
• Ensure that the collet size corresponds with the
shaft size of the accessory
• Keep the air vent openings clean and uncovered
• Handle and store grinding/cutting discs careful-
ly to avoid chipping and cracking
• Do not use damaged, deformed or vibrating
grinding/cutting discs
• Formounting/usingnon-Dremelaccessories observe
the instructions of the manufacturer concerned
• Before using the tool
• ensure that accessory is correctly mounted
and firmly tightened
• check if accessory runs freely by turning it by
hand
• test-run tool for at least 30 seconds at highest
no-load speed in a safe position
• stop immediately in case of considerable
vibration or other defects and check tool to
determine the cause
• ! Never use a cutting disc for side grinding
• When grinding metal, sparks are generated;
keep other persons and combustible material
from work area
• Wear protective glasses and gloves, hearing
protection, a dust mask, and sturdy shoes; when
necessary also wear an apron
• Apply wire of bristle brush lightly to the work as
only the tips of the wire/bristles do the work.
• ! The accessory continues to rotate for a short
time after the tool has been switched off
DREMEL CORDLESS TOOL SAFETY
• A battery operated tool with a separate battery
pack must be recharged only with the specified
charger for the battery.
• Use battery operated tool only with the specifi-
cally designated battery pack. Use of any other
batteries may create a risk of fire.
• Avoid accidental starting. Be sure switch is in the
off position before inserting the battery pack.
• Disconnect battery pack from tool or place the
switch in the off position before making any
adjustments, changing accessories, or storing
the tool.
• When the battery pack is not in use, keep it away
fromother metal objects like: paper clips, coins, keys,
nails, screws, or other small metal objects that can
make a connection from one terminal to another.
• Always hold the tool firmly in your hands during
the start-up.

BATTERY / CHARGER SAFETY

• Before using the battery charger, read all
instructions and cautionary markings on the 856
battery charger, 855 battery pack, and 800 product
using battery.
• Use only the charger which accompanied your
product or direct replacement as listed in the
catalog or this manual.
• Do not disassemble charger or operate the
charger if it has received a sharp blow, been
dropped or otherwise damaged in any way.
• Do not recharge battery in damp or wet environ-
ment. Do not expose charger to rain or snow. If
battery case is cracked or otherwise damaged,
do not insert into charger.
• Charge only Dremel No. 855 rechargeable bat-
teries with charger 856.
• Charge battery pack in temperatures above 0°C
and below 40°C. Store tool and battery pack in
locations where temperatures will not exceed
40°C or drop below 0°C .
• When damaged and under extreme usage and
temperature conditions, batteries in battery pack
may start to leak. If liquid comes into contact
with the skin, wash quickly with soap and water,
then with lemon juice or vinegar. If liquid gets
into eyes, flush eyes with clean water for a min-
imum of 10 minutes and seek immediate med-
ical attention.
• Place charger on flat, non-flammable surfaces
and away from flammable materials when
recharging battery pack.
• Use of an attachment not recommended or sold
by Dremel may result in risk of fire, electric
shock or injury to persons.
• Never charge battery pack outdoors.

BATTERY DISPOSAL

• Do not attempt to disassemble the battery or
remove any component projecting from the bat-
tery terminals
• At the end of the battery's useful life, do not
throw out the battery. Please bring your battery
to a proper battery disposal location or return
your batteries to one of the DREMEL service sta-
tions (address are listed on the service diagram
supplied with the tool)
12 12