Gima 28200 Manual Del Usuario página 21

21
ENGLISH
WARNING: The power supply cable plug is the element of separation from the electrical mains system: even
if the units equipped with a special on / off switch button, the power supply plug must be kept accessible once
the device is in use so as to allow a further method of disconnection from the mains supply system.
MULTIPURPOSE BAR- MPR SYSTEM
The device is equipped with a multipurpose bar to easily change accessories (such as rings of different diameters
for different collection vessel capacities, safety traps, cannula holders or standard 30x10 mm stainless steel
bar, on which any other accessory can be inserted using standard clamps).
USING THE FOOTSWITCH CONTROL:
Connect the footswitch control feeding cable with the plug marked as
After the device has been connected,all Leds are still off. When the ON/OFF button is pressed, all Leds are
activated at once for 1 second (autotest). At the end of the autotest cycle, the ON/OFF button led will flash.
Press the button marked as (---) to perform suction using the footswitch control and execute intermittence
work cycles. Press the button marked as (-) to perform remote suction using the footswitch control (continuous
suction). To stop suction just push on the footswitch control with strength.
USING THE FOOTSWITCH CONTROL AND THE FLOW DEVIATOR:
If using equipment fitted with a flow deviator, users may direct suctioned liquids in any of the two collection tanks
provided. Flow deviator comes with two complete suction kits (2 sets of tubes, 2 antibacterial and hydrophobic
filters and two conical junctions). After the device has been connected, all Leds are still off. When the ON/
OFF button is pressed, all Leds are activated at once for 1 second (autotest). At the end of the autotest cycle,
the ON/OFF button led will flash. To decide which side to perform the suction from, press OUT LEFT or OUT
RIGHT and the selected button led will show a blue light.
Press the ON/OFF button again to start the suction cycle. If the device is set up for using the flow deviator,
ensure the antibacterial filter has been positioned on both sides. Connect the footswitch control feeding cable
with the plug marked as