Blade Assembly; Light Kit Assembly. Pgs - Craftmade OV70AG Guia Del Usuario

8. Blade Assembly.

Locate 15 blade attachment screws and washers
in hardware pack. Locate 15 blade attachment
screws and washers in hardware packs. Hold
blade arm up to blade and align holes. Insert 3
blade attachment screws (along with washers)
with fingers first and then tighten screws
securely with a Phillips screwdriver. Repeat for
the remaining blades.
Slide blade arm through one of the openings on
motor housing, aligning holes in blade arm with
holes located on the underside of the motor
housing--refer to drawing at right.
arm with lock washers and blade arm screws.
Before securing screws permanently, repeat this
procedure with the remaining blade arms.
Securely tighten all screws.
Note: Tighten blade arm screws twice a year.
9. Light Kit Assembly.
Place the light kit fitter on its base to
disassemble it. Remove finial, hex nut and
rubber washer. Carefully lift the glass shade
cage from the light kit fitter base. Now,
carefully remove the glass shade and set in
a safe place for later use.
["Light Kit Assembly" continued on next
page.]
Attach blade
opening
glass
shade
page 7
blade attachment
screws and washers
blade
blade arm
lock washer and
blade arm screw
finial
hex nut
rubber washer
glass
shade
cage
light
kit fitter
light
kit fitter
base