What To Do If Cloning Fails - Motorola CLP Serie Guia Del Usuario

What to do if cloning fails

The radio emits an audible "bonk" indicating that
the cloning process has failed. In the event that
cloning fails, try performing each of the following
before trying to start the cloning process again.
1. Make sure that the radio batteries on both
radios are fully charged.
2. Verify the cloning cable connection on both
Single Unit Chargers.
3. Make sure that the battery is engaged
properly on to the radio.
4. Make sure that there is no debris in the
charging tray or on the radio contacts.
5. Verify that the source radio is in cloning
mode.
6. Make sure that the radio to be cloned is
turned ON.
7. Make sure that radios are both from the
same type (same frequency band, same
region and same transmission power).
Note: This cloning cable is designed to operate
only with compatible Motorola Solutions
Drop-in Tray Single Unit Charger. When
ordering the cloning cable, please refer to
CLP Series Cloning Cable Kit P/N
HKKN4028. For details about accessories,
refer to "Accessories" Section on page 36.
23
English