Allmatic B.RO X40 DISPLAY Manual Del Usuario página 33

• Output active, LED on.
• Output active and timed, slow blinking.
• Output delayed waiting for activation, fast blinking.
The receiver will enter the standby mode after 2 minutes of inactivity. The display shows
For exit the mode press brie! y a key of the receiver.
7
DISPLAY AND STATUS OF THE CONTROL UNITS
7.1 - NORMAL FUNCTIONING
Standby.
Outputs not activated.
Output 1 active.
Output 2 active.
Output 3 active.
Output 4 active.
Countdown associated to the output (in the example relay 4).
Displayed during the learning by default.
Displayed during the sequential learning.
Displayed during the advanced learning.
Displayed when a key of a new transmitter has been learned.
Displayed when a key of a new transmitter has been learned during the advanced learning.
Appears when learned one key of a transmitter already learned.
Indicates the position in the default transmitter memory.
Indicates the position in an already-learned transmitter memory.
Indicates a free position in the memory for the learning of a new transmitter.
Appears when the default parameters are restored.
Appears during the cancelation process of all the transmitters.
Appears when all the transmitters are canceled.
Appears when a single transmitter is canceled.
Appears during the reset of the transmitters, if memory is not present.
Appears when the control unit is waiting for a signal from a transmitter during the remote control
assessment mode.
7.2 - ERROR REPORTING
Memory not found, not assembled, not electrically functional.
Wrong memory size.
Memory full.
Incorrect coding type or not compatible with the detected memory, or wrong signature.
Wrong identifi er code (IdCode).
Supply voltage lower than 8.4 V - possible malfunction of the relays.
6-1620020 rev.0
ITA ENG
27/10/2015
FRA ESP DEU POR
and the LED OUT are disabled.
13/20