Allmatic B.RO X40 DISPLAY Manual Del Usuario página 25

3.3 - ADVANCED LEARNING
The advanced learning memorizes the single key of a transmitter.
During the learning phase it is possible to set the parameters of the memorized remote control. See paragraph 4 for more information
about single parameters.
The receiver exits from the learning phase after 10 seconds of inactivity or with the press of the MENU button.
Otherwise, if the remote is already memorized in that location, the display shows:
With UP (+) and DOWN (-) buttons it is possible to change the location where a
if the key is already memorized, the display shows the previous function of the
6-1620020 rev.0
Make sure that the receiver is out from any menu.
Press brie• y the MENU button.
Press a key of the transmitter.
Otherwise, if the remote is already memorized, the display shows:
Select the location of the transmitter in the memory with UP (+) and
DOWN (-) buttons of the receiver.
Press and hold the MENU button until the display shows:
Select the function of the key with UP (+) and DOWN (-) buttons.
Press and hold the MENU key until the display shows:
Enable/disable the key of the transmitter in the channel 1 with UP (+) and
DOWN (-) buttons of the receiver.
If the key is enabled, the display shows:
ITA ENG
27/10/2015
The display shows:
The display shows:
The display shows:
The display shows:
transmitter is stored.
key:
FRA ESP DEU POR
5/20