Position And Level The Tumbler - Alliance Laundry Systems DA0220SRG Instalación

Position and Level the Tumbler

Remove lint panel door, and unscrew the four shipping
bolts (one at each corner). Remove tumbler from skid.
NOTE: Do not throw bolts away – they are the
leveling legs.
Remove four nuts from the literature packet, and screw
one fully onto each leveling leg.
Screw the four leveling legs (bolts) back into the level
adjusting fittings from the bottom.
Slide tumbler to its permanent location. Adjust the
leveling legs until the unit is level within 1/8 inch
(32 mm). Tumbler must not rock. Lock leveling legs
with nuts installed.
IMPORTANT: Keep tumbler as close to floor as
possible. The unit must rest firmly on floor so
weight of tumbler is evenly distributed.
1
1 Plastic Cap
2 Leveling Leg
Figure 2
70223701
T451I
2
T451I
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Stacked Tumblers Only:
The stacked tumbler (300D) has a fifth leveling leg
which is enclosed with this manual. It MUST BE
installed on the lower left side of the blower housing to
stabilize the tumbler. Refer to Figure 3.
After leveling with the four cabinet leveling legs,
install the fifth so that it contacts the floor.
CAUTION
The stacked drying tumbler has a 5th
leveling leg on the blower housing. It is
very important to properly adjust this leg.
Unit is back heavy and could rock or tip.
1
1 Fifth Leg
Figure 3
Installation
W250
T467I
T467I
23