Fagor 8H-755BB Manual De Instrucciones página 47

OPERATION
Turn on the power.
When you connect the power supply (or
power is restored after a power outage) the
appliance will prompt to set the current time,
0.00 will flash on the display. Press the touch
sensor . Turn the +/– knob to adjust the
time. You must set the current time to use
the appliance.
The function dial must be in position 0 to con-
firm the time setting. If the function selector
dial is in a different position, the
flashes and the appliance waits until you turn
the function selector dial to 0.
Press the touch sensor
and the appliance enters standby.
Note: In the event of a power outage, all
settings such as Duration, Temperature and
Heating Function will be lost. You will need
to re-enter the settings to continue cooking.
If the pyrolytic cleaning is interrupted (or the
door is locked for any other reason – the
is on), the oven will start the cooling and door
opening procedure before you can set the
time. If temperature above 80°C is detected
in the oven, cooling fan is activated and this
does not affect the time adjustment process.
Cooling fan turns off when the temperature
drops below 75°C.
Standby mode
Switch the appliance to standby mode to re-
set all time, temperature and timer settings.
Heaters are disconnected. The display
shows the current time and has reduced
brightness. Press the
adjust the time, tone and brightness, and
press the touch sensor to adjust the min-
ute minder time setting.
If the temperature in the oven cavity exceeds
80°C, the current oven cavity temperature is
displayed (to indicate the residual heat) and
indicator
to save the time
touch sensor to
the cooling fan operates. When the temper-
ature drops below 75°C, the cooling fan is
turned off and the current time is displayed
instead of oven cavity temperature.
The appliance enters standby:
- turn the function selector knob to position 0
at any time, you will hear a beep;
- after a power outage when set the current
time;
- after a timed programme completes (timed
delayed operation, timed operation, minute
minder;
- after activation of the Auto Shut-off Safety
Device
- after 5 seconds of inactivity during temper-
ature setting (when selecting a new heating
function, when adjusting an active heating
function the appliance continues to operate
normally);
- when you turn the knob to position 0 dur-
ing a pyrolytic cleaning cycle, the appliance
activates cooling fan to unlock the door, and
enters standby only after the appliance has
cooled down and the door is unlocked.
Activate the appliance from the standby
mode:
Turn the knob from 0 to any available func-
tion to activate the appliance from standby.
Note - if the appliance entered the standby
mode automatically, you need to first turn
the knob to 0 and only then to another func-
tion.
When the appliance is in standby mode and
the function knob is in a position other than
0 - the indicator flashes.
Set current time
You can set the current time in standby only.
Press the touch sensor in this mode to
display the current time with normal bright-
ness. Use the +/– knob to adjust the current
47