Wall Mount Installation - Amplicomms BigTel Instrucciones De Uso

Wall mount installation

To mount the base unit (corded phone) on the wall you need 2
dowels and 2 suitable screws, preferably fillister-head screws,
dia. 4 mm. Fasten the screws 83 mm apart one below the other
in a vertical line so that the screw heads are about 3 mm from
the wall.
CAUTION: Know where your electrical wires and water
pipes are located before drilling!
1. Unplug the power adaptor cord and the telephone line cord
from the base.
2. Remove the retainer from the handset cradle, turn it 180º
and reinsert it in the cradle.
3. Grasp and squeeze the tabs as indicated by the arrows to
open the hinged bracket. Route the telephone line cord and
the power adaptor cord through the hole of the wall mount
bracket. Push the end of the telephone line cord into the
telephone jack and push the connector of the power adaptor
into the power cord jack on the underside of the phone.
8
Helpline 0844 800 6503 (See page 52 for costs and hours of operation)