Set Up Your Phone System; Location; Connect The Base Unit - Amplicomms BigTel Instrucciones De Uso

Set up your phone system

Location

Place the base unit (corded phone) near a mains socket and a
telephone wall jack to ensure that the connection cables are
long enough. Keep the unit approx. 1 m away from other
electronic devices to prevent interference. The corded phone
uses radio signals to connect with the cordless handset. Signal
strength depends on the base unit's location. The maximum
range is 300 m based on an unobstructed line of sight; the range
is shorter inside buildings because of walls and other obstacles.

Connect the base unit

1. Plug the connector on the cable end into the corresponding
jack on the underside of the base and plug the power
adaptor into the wall socket.
2. Plug the small connector on the end of the telephone line
cord into the corresponding jack on the base and plug the
other end into the telephone jack.
3. Connect the receiver with the telephone using the coiled
receiver cord.
Note: Guide the connection cables through the strain-relief tabs
on the base so the unit sits flush with the desk.
Helpline 0844 800 6503 (See page 52 for costs and hours of operation)
5