Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Accuracy of the Plumb Beam to the Floor and the
Laser Cross against the Ceiling
Mount the measuring tool on a tripod (accessory). Make
sure that the tool is 1.2 m away from the floor.
Switch the downward plumb point on and mark point
a
.
1
Rotate the tool by 180° and mark point a
Points a
and a
should be approx. above each other.
1
2
Application Examples
Levelling, Projecting Height Points/Heights
Level the laser to the requested height. Mark points on
the laser line or project the height difference between
laser beam and the required height using a metre rule.
Plumbing
Position the laser in order to project a point from the cei-
ling onto the floor or opposite, exactly above the point
to be projected and mark the other side.
Projecting 90° angles
Switch the vertical lines on. Position the plumb beam
above the corner point, align a vertical laser line to a
given edge using the fine-adjustment knob and mark
the required connection points at the other vertical lines.
Maintenance and Cleaning
J Do not use aggressive cleaning agents or solvents.
Clean the laser exit windows with a soft cloth.
If the machine should happen to fail despite the care ta-
ken in manufacture and testing, repair should be car-
ried out by an authorized customer service agent for
Würth power tools.
For all correspondence and spare parts orders, always
include the article number on the type plate of the ma-
chine.
Only for EC countries:
Do not dispose of power tools into household waste!
According to the European Directive 2002/96/EC on
waste electrical and electronic equipment and its incor-
poration into national law, power tools that are no lon-
ger suitable for use must be separately collected and
sent for recovery in an environmental-friendly manner
.
For this Würth tool, we provide a warranty in accor-
2
dance with statutory/country-specific regulations from
the date of purchase (proof of purchase by invoice or
delivery note). Damage that has occurred will be cor-
rected by replacement or repair.
Damage caused by normal wear, overloading or im-
proper handling is excluded from the warranty.
Claims can only be accepted if the power tool is sent un-
disassembled to a Würth branch office, your Würth sa-
les representative or a customer service agent for Würth
compressed-air and power tools.
Declaration of Conformity
We declare under our sole responsibility that this pro-
duct is in conformity with the following standards or
standardization documents: EN 61000-6-1,
EN 61000-6-3, EN 50082-1, ICE 60-825-1 according
to the provisions of the regulations 89/336/EWG.
08
Adolf Würth GmbH & Co. KG
P. Zürn
Subject to change without notice
Disposal
Power tools, accessories and packaging
should be sorted for environmental-friendly
recycling.
Warranty
A. Kräutle
13
Tabla de contenido
