Changing The Batteries; Tyre Changing - Vermeiren Express V Manual De Instrucciones

Ocultar thumbs Ver también para Express V:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

3.5

Changing the batteries

L L L L
CAUTION:
Risk of burns – Do not come in contact with the acid from the
batteries. See for a good ventilation of the battery compartment.
The battery shall be changed by trained personnel.
3.6

Tyre changing

L L L L
CAUTION:
There must be no air in the tube before the tyre can be removed.
L L L L
CAUTION:
Risk of damage - If handled improperly, the rim might become
damaged.
Only an expert can guarantee correct assembly. Work not done by your specialist
dealer, would void any warranty claims.
Use only inflating equipment which complies to regulations and indicates the pressure in bar.
We do not accept any liability for damage caused by using inflation equipment or wheels not
supplied by the manufacturer.
L L L L
WARNING:
Risk of injury - Check that the pressure is correct.
L L L L
CAUTION:
Risk of injury - Make sure that no objects, body parts or inner tubes
are pinched between the tyre and the rim when mounting a tyre.
Steering wheels (front wheels)
Removing tyre from rim:
1. Let all the air out of the tube.
2. Insert a tyre lever between the tyre and the rim.
3. Slowly and carefully push the lever downwards. This will pull the tyre over the edge of the
rim.
4. Move the lever along the rim, the tyre will jump out.
5. Now carefully remove the tyre from the rim and then remove the tube.
Note the following before inserting the new tube:
Check the rim bed and the inside wall of the tyre for foreign matter and clean these properly
if necessary. Check the condition of the rim bed, especially around the position of the air
valve. Please use only genuine original replacement parts. No liability is accepted for
damage caused by non-genuine replacement parts. Kindly contact your specialist dealer.
The battery can be changed according following
steps:
1. Remove the battery housing from the wheelchair.
2. Remove the battery cover
.
3. Disconnect all the wires on the batteries, power
module.
4. Lift the batteries
out the battery housing.
5. Place the new batteries in the battery housing.
6. Connect all the wires to the batteries.
7. Replace the battery cover
Page 25
Express V
2013-06
by loosen the belt
with the belt
.
Tabla de contenido
loading

Tabla de contenido