Assembly tyre from rim:
Put the deflated tube around the center of the rim. Make sure that the
valve juts out the valve opening in the rim.
Push the tyre over the edge of the rim, starting behind the air valve. Inflate
the tube slightly until it is round, and place it inside the tyre.
If the tube fits snugly inside the tyre without any folds (in the case of folds:
let out some air), then the upper side of the tyre can be pressed lightly
onto the rim with both hands, starting at the air valve.
Check all around on both sides that the tube is not pinched between the rim and the edge of
the tyre. Lightly push the air valve inwards and pull it out again to make sure that the tyre is
positioned properly in the region of the air valve.
To ensure that the wheel is inflated correctly, admit only so much air initially that the tyre can
still be easily pushed inwards by using your thumbs. If the check-lines are equidistant from
the edge of the rim on both sides of the tyre, then the tyre is centered properly. If not - let out
the air and position the tyre afresh. Now the tyre can be inflated to its full operating pressure
(note the maximum) and the valve cap should be replaced.
When inflating the tyres, always check that the pressure is correct. The correct pressure is
given on the tyre sides.
•
Driving wheels (rear wheels)
L L L L
WARNING:
Risk of injury - Make sure all screws are firmly secured by hand
before driving with your electric wheelchair.
DISMANTLING
1. Loosen and remove the wheel fastenings
2. Take the complete rear wheel
ASSEMBLY
1. Make the threads and Motor axle free from dirt and grease the threads.
2. Mount the rear wheel on the motor axle so that the wheel hub fits on the motor axle
groove.
3. Secure the wheels firmly with the nut (wheel fastenings
4
Maintenance
For the maintenance manual of the electric wheelchairs refer to the Vermeiren website:
www.vermeiren.be.
1 = Motor axle
2 = Rear wheel
3 = Wheel fastening
.
from the motor axle
.
Page 26
Express V
).
2013-06