Maintenance And Storage - Lanaform Dobra Manual Del Usuario

outlet pipe . Make sure that this and
[ insert_p 1 label 4]
the closing cover of the mist outlet pipe
are in the right position.
label 5]
Adjusting the mist intensity
Press the touch control button
peatedly to adjust the emission of cool mist:
• press once: maximum intensity is selected
(approximately 150 ml/hr). The LED indica-
tor under the symbol "H" lights up.
[ insert_p 1 label 15]
• Press twice: minimum intensity is selected
(approximately 120 ml/hr). The LED indica-
tor under the symbol "L" lights up.
[ insert_p 1 label 15]
• Press 3 times: the humidifier runs on
"night" mode. The white atmospheric light
is then disabled and the light indicator
" brightne " goes out after 3 seconds.
[ insert_p 1 label 15]
When there is no water left in the reservoir,
the humidifier stops and the indicator dis-
plays red for 5 seconds. You can also stop it
at any time by pressing a fourth time on the
touch control button.
Light settings
When the device lights up, it does not emit
any atmospheric light by default.
• Press the button that chooses the light
mode once: a warm white light
[ insert_p 1 label 17]
is activated.
• Then press the button that selects the light
mode repeatedly to change the
[ insert_p 1 label 17]
temperature of the white light to a neutral
then cool white light.
• Press a fourth time and the light will go out.
Important notes
• Use only clean distilled or demineralised
water in order to avoid any malfunction.
• Do not pour water into the exhaust pipe
to prevent any dysfunction and fire risk.
label 10]
• Make sure you close the reservoir lid
hermetically.
label 1]
• The reservoir must be kept clean. If there
is any dirt on the vapour emission diffuser
sprinkler tip, clean it with a brush or a
damp cloth.
Please note: even though there
report_p
is a safety device that stops the
transducer from working, do
not leave the device connected
when you are not using it.
Additional information about
report_p
the use of essential oils:
Before using essential oils, please check the
harmful effects that use of these products
may have on your health.
Always choose quality essential oils that are
pure, 100 % natural and intended for diffusion.
Use them in moderation and with care. Follow
the instructions and warnings stated on the
packaging of the essential oils, in particular
noting that:
E-IM-Dobra-LA120124-001-2019-v1.0.indd 5
• Pregnant women, people with epilepsy,
asthmatics and people who suffer from
[ insert_p 1
allergies, those with heart problems or se-
[ insert_p 3]
rious illnesses should not use essential oils.
• Essential oils should be used only for peri-
ods not exceeding 10 minutes in the room
re-
[ insert_p 1 label 16]
of a baby (under 3 years old) and only
when the baby is not actually in the room.
• Make sure that children and minors do
not play with or use the device.
• Just a few drops (3 to 4 drops at most) of
essential oils are sufficient to ensure that
the device works properly and the scent
is diffused. Excessive use of essential oils
could damage the device.
• Make sure you pour water into the res-
ervoir first before adding the drops of
essential oils.
• Lanaform cannot be held liable in the
event of accidental damage resulting from
any use contrary to the instructions given
in these instructions for use.

MAINTENANCE AND STORAGE

Always switch off the humidifier before per-
forming any maintenance or storage activities.
If the water contains too much calcium and
magnesium, it may deposit a white powder
in the device. If this foam is deposited on
the transducer
Dobra humidifier from working properly.
Maintenance
We recommend
1 using clean distilled, demin-
eralised or boiled water each
time the device is used.
2 Cleaning the reservoir every 2 days and
cleaning the transducer every week.
[ insert_p 1
3 Cleaning the device (see expla-
nations below) and making sure
[ insert_p 1
that all of its parts are complete-
ly dry when it is not in use.
To clean the reservoir [ insert_p 1 label 7]
1 Clean the basin with water using
a soft cloth, and use vinegar
if there are any foam or limes-
cale deposits on the inside.
2 Rinse the basin in clean water.
To clean the transducer [ insert_p 1 label 11]
1 Place 2 to 5 drops of vinegar on its
surface and leave for 2 to 5 minutes.
2 Brush the foam off the surface
using a soft brush. Do not use a
hard tool to scrape the surface.
3 Then rinse the reservoir in clean water.
To clean the mist outlet
1 Remove the unit's reservoir cap
2 Turn the reservoir lid
3 Remove the mist outlet pipe cap
4 Clean it all with a brush or damp cloth
5 Position the ring and the mist
6 Close the reservoir cap by turning it in
To clean the diffuser
1 Clean it with a brush or damp cloth.
2 Rinse the vapour emission
, this will prevent the
[ insert_p 1 label 11]
TROUBLESHOOTING
sentimen No operating indicator light, no mist.
help_out No voltage, no current.
sentimen Check whether the device is connected
sentimen Red indicator light flashing
help_out No water in the reservoir.
sentimen Pour clean, fresh, distilled or
sentimen The mist has an unpleasant odour.
help_out The device is new.
sentimen Drain the water from the reservoir
help_out The water is polluted or has been
sentimen Unplug the device, drain the water
EN
FR NL DE ES IT PL CS SK SL HR BG
Do not use soap, solvent
report_p
or spray cleaner to clean
the transducer.
pipe [ insert_p 1 label 3]
in
[ insert_p 1 label 1]
an anti-clockwise direction.
as well as the ring.
[ insert_p 1 label 4 & 5]
and vinegar if there are any foam or
limescale deposits on the inside.
outlet pipe cap again as indi-
cated on diagram .
[ insert_p 3]
an anti-clockwise direction, making sure
that the notches are correctly inserted
into those of the mist outlet pipe.
nozzle of the device [ insert_p 1 label 2]
sprinkler tip in clean water.
Storage
If you do not intend using the device for a
lengthy period, store the clean, dry humidifier
in a cool, dry place out of direct light.
In the event of a malfunction under nor-
mal conditions of use, please refer to the
following list.
and that there is no mains fault.
5 times, no mist.
demineralised water into the reservoir.
and leave the reservoir to air
out for at least 12 hours.
in the reservoir too long.
from the reservoir, rinse and clean the
reservoir, and fill the reservoir with
demineralised or distilled water.
5
23/09/2019 09:10:40
.
[ insert_p 1 label 1]
/ 36 English