Installation guide
9.2 Restoring the original configuration
This reset deletes all the stored control points, sensors and favourite positions and
reinitialises the direction of rotation of the Oximo 50 S auto RTS motor.
Caution! Only switch off the current for the motor to be reset!
Caution! Do not use the Inis RT/Inis RTS control point for resetting!
Place the roller shutter in the mid-height
-
position.
Cut the power supply for 2 seconds.
1)
Switch the power supply back on for 5 to 15
2)
seconds.
Cut the power supply for 2 seconds.
3)
Switch the power supply back on:
4)
The roller shutter moves for several
seconds.
Caution: if the roller shutter is in the upper or lower
end limit position it will move up and down briefly.
Press the PROG button on the RTS control point
5)
(K):
The roller shutter will move up and down
twice after an interval of several seconds.
All RTS control points, RTS sensors and the
favourite position (my) have been cleared.
Follow the procedures in the section entitled
-
--"Commissioning" to confirm the automatic
adjustment of the Oximo 50 S auto RTS motor.
9.3 Replacing a lost or broken RTS control point
This reset deletes all the stored control points, but the sensors, favourite position,
direction of rotation and end limits are kept.
Caution! Only switch off the power for the motor to be reset.
Place the roller shutter in the mid-height position.
-
Cut the power supply for 2 seconds.
1)
Switch the power supply back on for 5 to 15
2)
seconds.
Cut the power supply for 2 seconds.
3)
Switch the power supply back on:
4)
The roller shutter moves for several
seconds.
Caution: if the roller shutter is in the upper or lower
end limit position it will move up and down briefly.
Copyright © 2008 Somfy SAS. All rights reserved.
Oximo 50 S auto RTS
OFF
1
2
2 seconds.
OFF
3
4
2 sec.
5
PROG.
K
X2
OFF
1
2
2 seconds.
OFF
3
4
2 seconds.
ON
10 seconds.
ON
M
N
my
ON
10 seconds.
ON
61