Kohler K-10332 Manual Del Usuario página 7

Coupling
Nut
3. Supply Connections
If the lavatory is not installed, install it at this time according to
the lavatory manufacturer's instructions.
Connect the faucet supply shanks to the supply lines with the
coupling nut. (Left is hot - right is cold.) Securely tighten the
coupling nuts.
Tighten all connections.
4. Installation Checkout
Connect the P-trap.
Make sure all connections are tight.
Remove the aerator by turning it counterclockwise.
Open the drain.
Turn on the main water supply and check for leaks. Adjust as
needed.
Open both hot and cold valves and run water through the spout
for about a minute to remove debris. Check for leaks.
Close the hot and cold valves.
Remove any debris from the aerator and reinstall.
Kohler Co.
Shank
Supply
Tube
Supply
Stop
7 1048639-2-C