Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Operation
Floor fixing dimensions
of the outdoor unit
(Unit:mm)
Emergency operation and test operation
Emergency Operation:
HSU-09H03/R2(DB)
HSU-12H03/R2(DB)
HSU-12HB03/R2(DB)
Carry out this operation only when the remote controller is defective or lost.
HSU-18H03/R2(DB)
HSU-12HD03/R2(DB)
When the emergency operation switch is pressed, a" Pi "sound starts once, which
means the start of this operation.
In this operation, it is not possible to change the
settings of temperature and air flow speed, it is
Fixing of outdoor unit
also impossible to do an operation by the timer.
Follow the requirements below.
Room
Designated
temperature
temperature
o
More than 23
C
Indoor Unit
o
Less than 23
C
Place, robust not causing vibration, where the body can be supported
sufficiently.
If an air conditioner is a model for both cooling and heating.
Place, not affected by heat or steam generated in the vicinity, where
inlet and outlet of the unit are not disturbed.
Cooling when the room temperature at the start of operation is above 23
Place, possible to drain easily, where piping can be connected with the
Heating when the room temperature at the start of operation is below 23
outdoor unit.
Place, where cold air can be spread in a room entirely.
Place, nearby a power receptacle, with enough space around. (Refer
Test operation:
to drawings).
Place where the distance of more than lm from televisions, radios,
wireless apparatuses and fluorescent lamps can be left.
Use this switch in the test operation when the room
In the case of fixing the remote controller on a wall, place where the
temperature is less 16
indoor unit can receive signals when the fluorescent lamps in the room
are lightened.
operation.
Continue to press the test operation switch for more
than 5 seconds. After you hear the "Pi" sound twice,
release your finger from the switch, the cooling
operation starts with the air flow speed setting "Hi".
Before inserting power plug into receptacle, check the voltage without fail. The power source is the same as the corresponding name p
Removal of the restriction of emergency or test operation:
Install an exclusive branch circuit of the power.
A receptacle shall be set up in a distance where the power cable can be reached. Do not extend the cable by cutting it.
Press once more the emergency operation switch, or manipulate through the remote
controller, a "Pi" sound causes the restriction of emergency or test operation to be
removed.
When the remote controller is manipulated for the removal, then the selected operation
by the remote controller.
To this unit, both liquid and gas pipes shall be insulated
as they become low temperature in operation.
Use optional parts for piping set or pipes covered with
equivalent insulation material.
The thickness of the pipe must be 0.8mm at least.
Fix the unit to concrete or block with bolts( 10mm) and nuts firmly and horizonta
When fitting the unit to wall surface, roof or rooftop, fix a supporter surely with na
or wires in consideration of earthquake and strong wind.
If vibration may affect the house, fix the unit by attaching a vibration-proof mat.
Timer
Air flow
mode
speed
o
26
C
CONTINUOUS
AUTO
Selection of Installation Place
o
23
C
AUTO
CONTINUOUS
o
C, do not use it in the normal
Power Source
Selection of pipe
113.5
583
Floor fixing dimensions
of the outdoor unit
(Unit:mm)
Operation
mode
COOL
HEAT
Place, which is less affected by rain or direct sunlight an
sufficiently ventilated.
Place, possible to bear the unit, where vibration and nois
not increased.
Place, where discharged wind and noise do not cause a
nuisance to the neighbors.
Place, where a distance marked
in the above figure.
11
Liquid pipe
Gas pipe
113.5
HSU-22H03/R2(DB)
Pi
Outdoor Unit
o
C.
o
C
is available as illustr
Pi Pi
HSU-09H03/R2(DB)
HSU-12H03/R2(DB)
HSU-12HB03/R2(DB)
HSU-18H03/R2(DB)
HSU-12HD03/R2(DB)
HSU-22H03/R2(DB)
6.35mm(1/4")
6.35mm(1/4")
9.52mm(3/8")
12.7mm(1/2")
Tabla de contenido
