Installation Of Hanger Bracket - Emerson ASHLAND CF717AP02 El Manual Del Propietario

5. Installation of Hanger Bracket

CAUTION
!
To reduce the risk of injury, install the fan so that the
blades are at least 7 ft. (2.1m) above the floor (Figure 11).
WARNING
!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box before wiring. All wiring
must be in accordance with National and Local codes
and the ceiling fan must be properly grounded as a
precaution against possible electrical shock.
WARNING
!
The outlet box and joist must be securely mounted and
capable of supporting at least 50 lbs. Use only a U.L.
outlet box listed as "Acceptable for Fan Support of
22.7 kg. (50 lbs.) or less".
WARNING
!
To reduce the risk of fire, electric shock, or personal
injury, mount fan to outlet box marked "Acceptable
for Fan Support of 22.7 kg. (50 lbs.) or less", and
use screws supplied with outlet box. Most outlet
boxes commonly used for support of light fixtures
are not acceptable for fan support and may need to be
replaced. Consult a qualified electrician if in doubt.
5.1
Unscrew (but do not remove) the Two Mounting Screws
in the Outlet Box (Figure 12). Position the Hanger
Bracket on the Outlet Box so that the T-slots in the
Hanger Bracket are aligned with the Outlet Box Screws.
Figure 11
T-SLOT
Figure 12
Please contact 1-800-654-3545 for further assistance
9
CEILING
7'
MIN.
FLOOR
OUTLET BOX
LOOSEN TWO
SCREWS (SUPPLIED
WITH OUTLET BOX)
SLIDE THE HANGER
BRACKET ONTO
THE OUTLET BOX
SCREWS, THROUGH
THE T-SLOT
HANGER
BRACKET
emersonfans.com
ETL Model No.: CF717-2