Rinse Aid; Water Pressure; Water Temperature - IKEA LAGAN Manual De Usuario

EN

Rinse Aid

Rinse aid greatly improves drying,
reduces water spots, filming, and
lubricates wash arm bearing for proper
rotation. With it water "sheets" off dishes
rather than forming water droplets that
cling and leave spots.
A dispenser, located next to the
detergent cup, automatically releases a
measured amount of rinse aid during the
last rinse. If spotting and poor drying are
problems, increase the amount of rinse
aid dispensed by rotating the dial to a
higher number. The dial is located under
the dispenser cap. The indicator will be
dark when full and will show clear when
it is time to refill.
To add liquid rinse aid, turn dispense cap
1/4 turn counterclockwise and lift out.
Pour in rinse aid until liquid touches the
indicated fill level Replace cap.
Do not overfill since this can cause
oversudsing. Wipe up any spills with a
damp cloth.
The dispenser holds enough for 35 to
140 washes, depending on setting.
Dispenser Opening
Dispenser Cap
The HEAT DRY option in combination
with rinse aid will enhance drying
performance. The energy required
to use the HEAT DRY option costs
pennies per cycle. You may choose
not to select the HEAT DRY option;
however you will have items in your
dish load that will not be completely
dry at the end of the cycle.
OPERATING INSTRUCTIONS
Indicator
Adjustable Setting

Water Pressure

The hot water line to dishwasher must
provide water pressure between 20 and
120 psi.
Low Water pressure may occur when
laundry or showers are in operation. If
you experience poor wash performance
you may need to wait until water use is
reduced before starting dishwasher.

Water Temperature

Hot water is needed for best dishwashing
and drying results. Water entering
dishwasher should be at least 120°F
(49°C) to give satisfactory results.
To check water temperature entering
dishwasher:
• Turn on hot water faucet nearest
dishwasher for several minutes to
clear cool water from pipes.
• Hold a candy or meat thermometer
in the water stream to check the
temperature.
• If temperature is below 120°F
(49°C), have a qualified person raise
the hot water heater thermostat
setting.
IMPORTANT
Before starting a cycle, run hot water
to clear cool water from pipe.
13