Mounting The Fuel Save Controller - SMA FUEL SAVE CONTROLLER 2.0 Instrucciones De Instalación

5 Mounting
5.2

Mounting the Fuel Save Controller

Figure 5: Dimensions of the Fuel Save Controller
Risk of injury from the Fuel Save Controller falling
The Fuel Save Controller is very heavy. There is risk of injury if the Fuel Save Controller is lifted incorrectly or falls
during transport or mounting.
• Two persons are required for mounting and removing the Fuel Save Controller.
• Take the weight of the Fuel Save Controller of approximately 48 kg into consideration.
• Wear suitable personal protective equipment, e.g. safety shoes, when mounting the Fuel Save Controller.
• Use mounting material suitable for the support surface when mounting the Fuel Save Controller.
Additionally required mounting material (not included in the scope of delivery):
☐ Four screws, washers and fastening material suitable for the support surface
Procedure:
1. Attach the wall mounting bracket to the enclosure using
fastening material (torque: 10 Nm to 15 Nm).
2. Mark the position of the drill holes and drill the holes (diameter: 10 mm).
16 FSC20-IA-xx-20
SMA Solar Technology AG
Installation Manual