Connecting The Power Cable; Automatic Power-Switching Function; Setting The Auto Standby Switch - Yamaha NS-SW1000 Manual De Instrucciones

Connecting the power cable

Plug the supplied power cable into the AC IN of this unit
after all other connections are complete, and then plug the
power cable to an AC outlet.
To AC outlet
Note
• Do not use other power cables. Use the provided cable. Use of
other power cables may result in fire hazard or electrical
shock.
• Be sure to use the power cable supplied with this unit. Using
a power cable other than the one provided may cause fire or
damage to this unit.
• Do not plug the power cable into the AC outlet of your
amplifier. Doing so may create distorted sounds or turn off
the power of your amplifier.

AUTOMATIC POWER-SWITCHING FUNCTION

This function automatically places the subwoofer in standby mode if the subwoofer does not detect a signal from the
amplifier for a certain period of time. The subwoofer automatically turns on as soon as it detects a signal from the
amplifier.
The Automatic power-switching function works as follows when the AUTO STANDBY (HIGH/LOW/OFF) switch is set
to LOW or HIGH. (Normally, set the switch to LOW.)
How the Automatic power-switching function works
The subwoofer automatically enters standby mode
if it does not receive an input signal (*1) from the
amplifier for 7 or 8 minutes (*2).
* The indicator color changes from green to red.
*1 When the Automatic power-switching function is enabled, the subwoofer will detect a bass signal input of below 200Hz (such as sound effects
of explosion in action movies, bass guitar or bass drum sound, etc.).
*2 This value may vary depending on the system environment. For example, it may be affected by noise generated from other equipment.
• The POWER switch on the rear panel ( page 4) must be set to ON in advance.
• The Automatic power-switching function can be activated when the following conditions are met:
-The unit is powered ON
-The AUTO STANDBY switch is set to LOW or HIGH
• If the STANDBY/ON switch on the front panel ( page 4) is pressed and the unit is turned OFF while the unit is in standby
mode (the indicator is lit in red), the Automatic power-switching function is canceled. Pressing the STANDBY/ON switch again
or turning the power of the component connected via system connection on again turns the unit power ON and the Automatic
power-switching function can be activated again.

Setting the AUTO STANDBY switch

Note
Be sure to set the POWER switch to OFF before you set the AUTO STANDBY switch.
LOW: The Automatic power-switching function activates at a certain level of input signal. To enable the function, select
this position.
HIGH:If the Automatic power-switching function does not work well when the AUTO STANDBY switch is set to LOW,
select this position. If the function still does not work, slightly raise the LFE LEVEL on the amplifier.
OFF: The Automatic power-switching function may unexpectedly activate due to the system environment, for example,
if the subwoofer detects noise generated from the peripheral components. In this case, select this position to disable
the Automatic power-switching function, and manually turn the unit on or off by using the POWER switch or the
STANDBY/ON switch.
Note
• The subwoofer uses a small amount of power in auto-standby mode.
• If you plan not to use the subwoofer for a long period of time, set the POWER switch on the rear panel to OFF, or unplug the
power cable from the AC outlet.
When the subwoofer detects an input signal (*1)
from the amplifier, the subwoofer automatically
turns on.
* The indicator color changes from red to green.
8
En