Tabla de contenido
Idiomas disponibles
Idiomas disponibles
b. From the opposite end of the Housing, install the hex
of the Torque Adjustment Screw onto the hex
wrench.
c.
Push the Screw and wrench toward the threaded hole
until it contacts the face of the Housing.
d. While applying finger pressure to the rivet end of the
Screw, rotate the wrench counterclockwise to thread
the Screw into the Housing. Continue rotating the
Screw until the rivet end stops against the face of the
Housing.
e.
Insert the two Adjustment Screw Plug Locks (38) and
the Plug Lock Spring (39) into the crosshole leading
to the Adjustment Screw. Thread the Plug Lock
Screw (40) into the same hole to capture the compo-
nents. (Refer to Dwg. TPD1286)
9. If the Oil Stop Cap Assembly (60) was removed from
the Front Liner Cover (56), install the Stop Cap O–
ring (61) and Back–up Ring (62) in the groove of the
Cap and insert the assembly into the Cover.
(Refer to Dwg. TPD1287)
10. Install the Liner Cover O–ring (44) in the groove on
the large hub of the Rear Liner Cover (43). Align the
pin holes in the face of the Cover with the two Liner
Pins (46) at the rear of the Liner and place the Cover
against the Liner. A groove will be formed between
the Liner and Cover for the Rear Liner Seal (64). Do
not attempt to put the Seal in the groove at this time.
11. Align the pin holes in the Front Liner Cover (56) with
the Pins in the front face of the Liner and place the
Cover against the face of the Liner. Another groove
will be formed between the Liner and Cover for the
MAINTENANCE SECTION
(Dwg. TPD1286)
(Dwg. TPD1287)
Front Liner Seal (63). Install both the Front and Rear
Liner Seals in the grooves at this time and stand the
assembly on the workbench with the output end of
the Drive Shaft upward. (Refer to Dwg. TPD1288)
12. Apply a thin film of grease to the Liner O–ring (41)
and install it in the forward bore of the Housing.
13. Lubricate the Front and Rear Liner Seals and after
orienting the Housing to the proper position, install
the Housing over the Liner.
14. Grasp the flats of the Housing in vise jaws with the
output spindle downward. Remove the Rear Liner
Cover Assembly and put grease in the central open-
ing of the Cover. (Refer to Dwg. TPD1289)
17. Make certain the Drive Shaft rotates freely and then
fill the mechanism with fluid and reassemble the tool
as instructed in the section, CHANGING THE
MECHANISM FLUID.
23
(Dwg. TPD1288)
(Dwg. TPD1289)
(Dwg. TPD1291)
Tabla de contenido
