Tools And Materials; Before You Begin - Kohler K-672 Manual Del Usuario

Tools and Materials

Tubing Cutter
Adjustable
Wrench
Blade
Screwdriver
Thank You For Choosing Kohler Company
We appreciate your commitment to Kohler quality. Please take a few
minutes to review this manual before you start installation. If you
encounter any installation or performance problems, please don't
hesitate to contact us. Our phone numbers and website are listed on
the back cover. Thanks again for choosing Kohler Company.

Before You Begin

CAUTION: Risk of product damage. Do not apply direct heat to
the transfer valve body. Excessive heat will damage the plastic
valve components and plaster guard.
Observe all local plumbing and building codes.
Do not remove the plaster guard from the transfer valve until
instructed to do so.
A mixed water supply is required for this transfer valve.
Do not plug any outlets on this transfer valve. The transfer valve
is not intended to be used as a shut-off valve.
If less than three accessories will be installed, connect the unused
transfer valve port to one of the accessories. All outlet ports must
be connected to an accessory, even if one accessory is connected
to two transfer valve outlet ports.
Carefully plan the installation before beginning. Carefully read
the entire instructions. Component location, spacing, and
situational requirements can vary.
Shut off the main water supply.
1041156-2-A
Solder
Plus:
• 1/2" Piping or Copper
Tubing for outlets
• 3/4" Piping or Copper
Tubing for inlets
Propane
Torch
2 Kohler Co.