Barrette BELLA PREMIER Serie Instrucciones De Instalación página 10

7.
For angles 34º-38°:
a. From the original line created by the post,
mark another line
bottom rail (closer to the baluster routes)
(Fig. 8). This is accomplished by using the
angle template (Fig. 9). This additional removal
of material will allow for bracket clearance
when the rail is installed. For this 34º-38º
angle, the new line will NOT be parallel to the
previously drawn line.
b. Set chop saw at 32°
c. Cut the bottom rail on the new mark at a 32°.
NOTE:
If your cut will result in a baluster route hole
being cut through, repeat Step 3 and add/
subtract a baluster route hole, re-center,
mark and proceed to Step 4.
d. The rail will not match the angle of the stair,
but instead match the inside of the bracket.
The outside of the brackets will be cut to the
proper angle in Step 11.
e. Go to Step 8.
8.
Place top rail flat on table. Lay the cut bottom rail
on top of the top rail, with the routed holes facing
in the same direction (Fig. 10). Line up the routes
(Fig. 11).
9.
a. Mark the top rail (using the bottom rail and a
steel rule as a guide) to the top edge of the rail
(Fig. 12).
b. Make sure to extend the line out at the angle
to the edge of the rail (mark line on "bump" of
bottom of top rail on angle, not straight down).
c. Cut the top rail to the lines using the chop saw
set to 32°.
10
⁄ " on the inside of the
11
16
Original Line Original Line Mark Here Mark Here
More than 33º More than 33º (32º) (32º)
Mark Here Mark Here
(32º) (32º)
pg-07_fig-05_angle-template Sunday, March 08, 2015 12:24:02 PM
Bottom Bottom
Rail Rail
Top Rail Top Rail
Bottom Bottom
Rail Rail
Top Rail Top Rail
Fig. 8
Fig. 9
Original Line Original Line
More than 33º More than 33º
Jay Harnish
Fig. 10
Fig. 11
Fig. 12