Installing The Charging Stand; Installation Guide - Samsung VS20R90 Serie Manual Del Usuario

Installing the charging stand

Installation guide

2
'Click'
1
3
2
1
3
24 26
inches inches
❇ ❇ Please refer to the QR code for detailed information on the installation and
charging method of the charging stand.
Assembling the charging stand
1 Place the stand pipe on the bottom support,
and screw the pieces together using the
included small screw.
– Make sure the pieces are aligned
correctly and push it in firmly so that the
screw hole is aligned.
2 Insert the vacuum charging part at the top
of the stand pipe.
– Do not disassemble it after attaching it.
3 Connect the power cord to the rear of the
4
charging stand.
– Hold the connection part of the cord and
push it onto the connection pins firmly
until the gray lines on the tip of the cord
are not visible.
– To make it easier to place the stand
directly against a wall, insert the cord
into one of the grooves on the bottom of
the bottom support.
4 Plug in the charging stand.
Fixing by the hook
1 Using the fixing hook as a template, mark
where the top and bottom screw holes will
be placed on the wall.
– Top: 26 inches from the floor
4
– Bottom: 24 inches from the floor
2 Drill the holes using a 1/4 inch. drill bit,
and put the provided screw anchors into
the hole.
3 Fix the fixing hook to the wall with the
provided screws (large).
4 Hook the groove of the charging stand into
the fixing hook.
English 17