C. GENERAL INSTRUCTIONS
• It is only suitable for use in vehicles fitted with automatic
3-point seat belts and ISOFIX anchoring systems, approved
under Standard ECE R16 and ECE R14 or other equivalent stan-
dards.
• Your GROOWY seat can be installed on the front seat or the
back seat of the vehicle. However, we recommend that you
install the safety seat on the back seat.
• Not all safety systems are exactly the same, therefore we ad-
vise you to test your GROOWY in the vehicle in which it is going
to be installed.
• It is very important not to use second hand products, because
JANÉ can only guarantee complete safety for articles used by
the original buyer.
• JANÉ recommends you replace your GROOWY safety seat
with a new one if it has been involved in an accident.
• Check that all the straps of the safety seat are in the correct
position and properly fitted to your GROOWY.
• Make sure that none of the straps are twisted.
• Make sure the child understands that he must never tamper
with the belts or the fastenings.
• Do not install the safety seat on side seats or rear facing
seats, this would be very dangerous.
• In some cars the seat belt buckle strap is quite far forward,
so it may come into contact with the edge of the booster seat,
which is not safe. In this case, try moving the vehicle seat
40
EN
forward or install the safety seat on another seat in the vehi-
cle.
• GROOWY has been designed for use in the car, it must not be
used out of the vehicle
• This is an "i-size" Child Safety Seat. It is approved under UN
Standard No. 129, for use on vehicle seats with "i-size compa-
tibility", as stated by the vehicle manufacturer in the vehicle
instruction manual.
• If in any doubt, consult the Restraint System manufacturer or
dealer.
• IMPORTANT: DO NOT USE IN THE FORWARD FACING POSITION
UNTIL THE CHILD REACHES THE HEIGHT OF 100 CM (See ins-
tructions).
• For more information on the use and installation of the
GROOWY consult our web page www.janeworld.com