General Instructions - JANE DRIVE Manual De Instrucciones

C. GENERAL INSTRUCTIONS
In order to protect your baby adequately and to ensure
their comfort and stability in the car, the following instructions
must be strictly followed:
• It is only suitable for use in vehicles fitted with automat-
ic 3-point seatbelts and ISOFIX anchor points, approved
under Standard ECE R16 and ECE R14 or other equivalent
standards.
• Your DRIVE safety seat can be installed on the front or back
seat of your vehicle. Although, we advise you to install it on
the back seat.
• Not all safety systems are exactly the same, therefore we
advise you to check your DRIVE in the car in which it is going
to be fitted.
• It is very important not to use second-hand products, as
JANÉ can only guarantee complete safety with items used
by their first buyer.
• JANÉ recommends that you replace your DRIVE safety seat
with a new one if it has been subjected to violent stress in
an accident.
• Check that all the seat straps are in the correct position
and duly adjusted to your DRIVE. Make sure that none of
the straps are twisted.
• The child must understand that he must not play with the
straps or fasteners under any circumstances.
• Do not install the safety seat on sideways seats in the vehi-
cle or rear facing seats, this is very dangerous.
• In some cars the seat belt buckle strap is quite far forward,
so it may come into contact with the edge of the booster
seat, which is not the correct position. In this case, try mov-
ing the vehicle seat forward or install the safety seat on
another seat in the vehicle.
• You must explain to the child that he must never play with
the seat belts or fasteners.
OK
EN 41