Maintenance - Movement WIRE CROSSOVER Manual Del Usuario

7

MAINTENANCE

RECOMMENDATIONS
For greater durability of the equipment it is important to adopt the following precautions. If any part of the equipment breaks,
immediately stop using it until repair.
CLEANING
On a weekly basis, clean the equipment using a soft, nylon brush. Vacuum up any dust that has accumulated under the
equipments which may affect the functioning of the equipment.
Wait for the machine to dry completely to start a new workout. Never use acidic cleaning products. Never wash the equipment
with water or spray liquids.
PANELS
The function of the fairing is to protect the tower, in the event of damage, carry out immediate
replacement
COUNTER
If the meter is not working check the batteries. To do this, simply remove the top cowling and
replace the batteries that come with the equipment. If the problem persists, contact a service
center. To enter maintenance mode, a magnet must be applied to the counter (approaching
from the upper right corner) so that it will enter maintenance mode. The counter will display the
version, % of the battery from 0 to 100 and the total of repetitions, the information will be
shown automatically. To enter the meter maintenance mode it cannot be in standby mode and
must be charged. To remove the counter from stand by, a repetition must be performed.
HOW TO CHANGE THE BATTERY
Follow the steps below to replace the equipment batteries.
1- Insert a fixed
screwdriver into the
slot to remove cover.
3-
2- Remove the
batteries
to be replaced.
Assemble the 4- Finally, reinsert the
new batteries. cover and plastic
35
ATTENTION!
CHECK THE
CORRECT
POLARITY WHEN
PLACING THE
BATTERIES!
fasteners.