Dismantling; Disposal; Accessories; Additional Information - Dräger Polaris 50 Manual De Usuario

Polaris 50 Mobile
CAUTION

The luminaire head must be installed before the
spring force is adjusted.

Move the spring-balanced arm to the highest position.

Remove the lateral plastic covers and press the round
plastic flap upwards along the spring-balanced arm.

Adjust the screw with a 4 mm Allen wrench.

Turn the screw clockwise (+) to increase the spring force
(if the spring-balanced arm lowers).

Turn the screws anticlockwise (-) to reduce the spring
force (if the spring-balanced arm rises).

10. DISMANTLING

DANGER
Risk of death from electric shock.
Before dismantling the luminaire, disconnect all plugs from
the power supply.
WARNING
Risk of injury
The spring-balanced arm is under a high spring force. If
the terminal device is not in the uppermost position of the
spring-balanced arm, the spring-balanced arm will move
upwards rapidly and cause severe injury. Only dismantle
the terminal device when the spring-balanced arm is in the
uppermost position

10.1 Disposal

Do not discard the luminaire with household waste.
Follow local regulations and take the luminaire to a
waste disposal centre or give it to a dealer who
provides an appropriate service.
Cut the cable directly at the casing.
The products listed above are over 95% recyclable.
So that a high percentage of the used materials can
be either physically reused or used for energy after
the end of the service life for this product, the
luminaires have been designed with recycling in
mind. They do not contain materials that are
hazardous or require monitoring.

11. ACCESSORIES

Hand grip (order No. D10.295.000)

12. ADDITIONAL INFORMATION

The luminaire itself is maintenance-free.
Additional documents may be requested from the manufacturer
for this product.
Using this luminaire does not pose a risk to other equipment.
To save energy, the luminaire should be switched on only
when it is actually needed.
Any serious incident that has occurred with the product must
be reported to the manufacturer or its representative and the
responsible authorities of the country in which the user is
located.
ENG
37