Installing The Ceiling Tube - Dräger Polaris 50 Manual De Usuario

ENG

Draw 6 drill marks.
Observe the position of opening "A" for connecting the

current.
WARNING
Wear safety equipment according to the tool manufacturer's
instructions.

Drill holes and blow out with bellows.
135 mm
270 mm

Check the hole distances.

Hold the ceiling bracket against the ceiling and hammer
in the fastening anchor.
Tighten the fastener according to manufacturer's

instructions.
DANGER
Risk of death from electric shock.

Do not turn on the power supply before the luminaire
head has been installed.

This device must only be connected to a power grid
with a protective earth conductor (PE) to prevent the
risk of electric shock
28
A

Connect the power.

3.4. Installing the ceiling tube

A
Pull the ceiling tube cable through the opening "B" of the

ceiling holder.
Insert the ceiling tube "A" into the ceiling holder.

Tighten the safety screw "C"and the M8 nut.

D
Tighten the M8 safety screw "C" and the nut (20 Nm).

Tighten all 4 grub screws "D" (5 Nm).


Connect the ceiling tube plug to the power supply plug.

Slide the ceiling cover and ring over the ceiling bracket
and screw them tightly.
B
C
C