Taurus I603MT Manuel De Instrucciones página 19

Connecting the hob to the mains power supply
The power supply should be connected in compliance with the relevant standard, or a single-pole
circuit breaker. The appliance has a large power rating and must be connected to electricity by a
Qualified Electrician.
Notes:
1. If the cable is damaged or needs replacing, this should be done by an after-sales technician using
the proper tools, so as to avoid any accidents.
2. If the appliance is being connected directly to the mains supply, an omni polar circuit breaker must
be installed with a minimum gap of 3mm between the contacts.
3. The installer must ensure that the correct electrical connection has been made and that it complies
with safety regulations.
4. The cable must not be bent or compressed.
5. The cable must be checked regularly and only replaced by qualified technician.
Cautions
1. The hob must be installed by qualified personnel or technicians. Please never conduct the
operation by yourself.
2. The electric hob shall not be mounted to cooling equipment, dishwashers and rotary dryers.
3. The electric hob shall be installed such that better heat radiation can be ensured to enhance its
reliability.
4. The wall and induced heating zone above the work surface shall withstand heat.
5. To avoid any damage, the sandwich layer and adhesive must be heat resistant.
6. A steam cleaner is not to be used.
7. This electric hob can be connected only to a supply with system impedance no more than 0.427
ohm. In case necessary, please consult your supply authority for system impedance information.
Note: For some of the models, there might applied with a power cord with plug. If so, you can
directly plug in socket. Please keep power cord plug out after use, for those model power cord
with plug.