Important Information; Product Information; Product Modifications; Product Inspection - Kohler K-1025-H2 Guia De Instalacion

Important Information

WARNING: When using electrical products, basic precautions should always be followed,
including the following:
DANGER: Risk of electric shock. Connect only to a circuit protected by a Ground-Fault
Circuit-Interrupter (GFCI) or Earth-Leakage Circuit-Breaker (ELCB).
Two dedicated 220-240 V, 20 A, 50/60 Hz services are required. Each must be protected by a GFCI or ELCB.
A pressure wire connector marked "Ground" is provided within each wiring compartment. To reduce the risk
of electric shock, connect this connector to the grounding terminal of your electric service or supply panel
with a copper wire equivalent in size to the circuit conductors supplying this equipment.
A pressure wire connector is provided on the exterior of the pump or control within this unit. Use this
connector as a bonding conductor between this unit and all of the exposed metal in the vicinity, as needed to
comply with local requirements.
Provide access to components for servicing.
Grounding is required. The unit should be installed and grounded by a qualified service representative.
WARNING: Risk of electric shock. A licensed electrician should make all electrical connections.
WARNING: Risk of electric shock. Disconnect power before servicing.
WARNING: Risk of injury or property damage. Please read all instructions thoroughly before
beginning installation, including the following requirements.
NOTICE: Follow all local plumbing and electrical codes.

Product Information

Product Modifications
WARNING: Unauthorized modifications may cause unsafe operation and poor performance of
the custom system. Do not remove the pump from the pump box or make non-recommended
modifications to the system. Unauthorized modifications could adversely affect the performance
and safe operation of the unit. Kohler Co. shall not be liable under its warranty, or otherwise, for
personal injury or damage caused by any unauthorized modification.
The system is not designed for steam applications, and may not perform in a satisfactory manner as a steam
unit.

Product Inspection

Carefully unpack and inspect all components for damage. Return all materials to the cartons during
construction to prevent damage.

Factory-Assembled Features

Some components have been factory installed and others will require assembly. Components include a tower
with eight pre-assembled jets, a pump, a heater, a control, a footbath and an enclosure.

Connections and Service Access

Before installation, ensure proper access to the final connections.
NOTICE: Provide unrestricted service access to the pump. You must provide access for servicing the
pump, heater and control. The access must be located immediately next to the pump.
1032110-2-E 2 Kohler Co.