Set-Up Instructions - Campbell Hausfeld Cl150100 Instrucciones Originales

11. ALWAYS use attachments designed
for use with air powered tools.
Do NOT use damaged or worn
attachments.
12. Keep ALL nuts, bolts and screws
tight and ensure equipment is in safe
working condition.
13. ALWAYS secure workpiece in a vise
or clamp.
14. NEVER point an air tool at oneself
or any other person. Serious injury
COULD occur.
Operation
To remove nuts, turn the forward/reverse
dial to the right. To install nuts, turn the
forward/reverse dial to the left. Reverse
the procedure if the threads are left-
handed. Do not overtighten the nuts.
the nuts or bolts with the ratchet as
typically done with a hand wrench. This
can damage the tool by breaking parts in
the ratchet mechanism.
pull the hose to move the tool or a
compressor. Keep hoses away from
Figure 1
When tightening,
do not torque down
Never carry a tool
by the hose or
Option 1: Individual components
Filter
Option 2: 3 piece combo
Filter, Regulator, and Lubricator
www.campbellhausfeld.com
heat, oil and sharp edges. Replace any
hose that is damaged, weak or worn.

set-up InstRuctIons

Air tools require a supply of clean, dry air
at 90 PSI (6.2 bar). An air supply system
with filter, regulator, and lubricator (FRL)
as shown in Figure 1 should be used.
Campbell Hausfeld FRL model PA2104
(3/8 inch) or PA2114 (1/2 inch) is
recommended.
Water in the air supply can damage an air
tool. Drain condensate from compressor
tank and filter daily.
All hoses and fittings must be the correct
size and tightly fastened. Refer to chart
below for minimum sizes.
Tool Air Consumption
Less than 9 SCFM @ 100% usage
9 to 34 SCFM @ 100% usage
Greater than 34 SCFM @ 100% usage
Chart 1 - Suggested minimum hose diameter to
use based on 50 ft length hose and continuous
SCFM rating of tool. The use of fittings and longer
hose may require a larger diameter hose to be
used.
Regulator Lubricator
Cl150100, Cl154800
Hose ID
1/4 inch
3/8 inch
1/2 inch
3