THERMEx DAX Instrucciones De Uso página 47

B 540235068210082018
• The indicator will now flash with the number 0.
• Use the (+)- and (-)- symbols to adjust the time the after-run function should run. If '1' is selected, the after-run will run for 10 minutes, if '2'
is selected, after-run runs for 20 minutes, etc. The after-run function can be set for a maximum of 90 minutes.
• Confirm the selected time by pressing on the on/off after-run symbol.
• The indicator of speed will now display the speed at which the motor runs at and the panel indicator will flash to indicate the after-run
function is activated.
The after-run function can be interrupted earlier than requested by pressing the on/off after-run symbol or by switching off the hood, as de-
scribed in the section on "extraction" on page 46. If the after-run function is interrupted, the panel indicator will stop flashing.
Should it be desired to regulate the speed of the after-run function after it has been activated, then this is done using the (+)- and (-)-symbols
until the desired speed has been reached. The panel indicator will continue to flash to indicate that the after-run function is activated.
RECIRCULATION
The hood can be used for recirculation. This is used in kitchens and in locations where there is no possibility of venting into the open-air. The air
is first drawn through the grease filter and then through a filter with active carbon to remove odours.
NOTE: Recirculation filters must be used if the hood is to be used for recirculation. These are not included in the purchase of the hood, but can
be purchased separately.
MODEL OF HOOD
width: 600 mm
width: 900 mm
The recirculation filter is mounted on the steel filter as follows:
• Open the glass cover.
• Remove the steel filter.
Mount the recirculation filter on the steel filter.
• Replace the filters inside the hood.
• Close the glass door.
NUMBER OF FILTERS PRODUCT NUMBER FOR RECIRCULATION FILTER (1 PC.)
1
2
THERMEX DAx
535.23.0570.9
535.23.0575.9
47