PAPILLON Ranger 39 Manual De Instrucciones página 26

Ranger 39 (YD-KU03-38) & Ranger 46 (YD-KU01-45A)
A log lying on the ground
Saw down halfway, then roll the log over and cut
from the opposite side.
A log hanging off the ground
In area A, saw up from the bottom one- third and
finish by sawing down from the top. In area B,
saw down from the top one-third and finish by
sawing up from the bottom.
Cutting the limbs of Fallen Tree
First check to which side the limb is bent. Then
make the initial cut from the bent side and finish
by sawing from the opposite side.
Pruning of standing Tree
Cut up from the bottom, finish down from the top.
7.Maintenance
Before cleaning, inspecting or repairing
the unit, make sure that engine has
stopped and is cool. Disconnect the spark
plug to prevent accidental starting.

MAINTENANCE AFTER EACH USE
1. Air filter
Dust on the cleaner surface can be removed by
tapping a corner of the cleaner against a hard
surface. To clean dirt in the meshes, split the
cleaner into halves and brush in gasoline. When
using compressed air, blow from the inside.
To assemble the cleaner halves, press the rim
until it clicks.
2. Oiling port
Dismount the guide bar and check the oiling port
for clogging.
3. Guide bar
When the guide bar is dismounted, remove
sawdust in the bar groove and the oiling port.
Grease the nose sprocket from the feeding port
on the tip of the bar.
4. Others
Check for fuel leakage and loose fastenings and
damage to major parts, especially handle joints
and guide bar mounting. If any defects are found,
make sure to have them repaired before
operating the saw again.
26