Stopping The Engine - PAPILLON Ranger 39 Manual De Instrucciones

Ranger 39 (YD-KU03-38) & Ranger 46 (YD-KU01-45A)
[Caution]
Be sure to confirm brake operation during daily
inspection.
How to confirm:
3) Turn off the engine.
4) Holding the chain saw horizontally, release
your hand from the front handle, hit the tip of
guide bar to a stump or a piece of wood, and
confirm brake operation. Operating level
varies by bar size.
In case the brake is not effective, ask our dealer
for inspection and repairs.
If the engine keeps rotating at high speed with
the brake engaged, the clutch will overheat
causing trouble.
When the brake engages during operation,
immediately release the throttle lever to stop the
engine.
 STOPPING THE ENGINE
3. Release the throttle lever to allow the engine
to idle for a few minutes.
4. Set the switch to the "O" (STOP) position.
Carburetor anti-freeze mechanism
Operating chain saws in temperatures of 0-5℃ at
times of high humidity may result in ice forming
within the carburetor, and this in turn may cause
the output power of the engine to be reduced or
for the engine to fail to operate smoothly.
This product has accordingly been designed with
a ventilation hatch on the right side of the surface
of the cylinder cover to allow warm air to be
supplied to the engine and to thereby prevent
icing from occurring.
Under normal operating mode, i.e., in the mode
to which it is set at the time of shipment. However
when the possibility exists that icing may occur,
the unit should be setup operate the anti-freeze
mode before use.

HOW TO SWITCH BETWEEN OPERATING MODES
7. Flip the engine switch to turn off the engine.
8. Remove the cover to the air filter, remove the
air filter, and then remove the choke knob from
the cylinder cover.
9. Loosen the screws holding the cylinder cover
in place (i.e., the three screws on the inside
and the one screw on the outside of the cover),
and then remove the cylinder cover.
10. Press with your finger down on the icing
cap located on the right-hand side of the
cylinder cover to remove the icing cap.
Adjust the icing cap so that the "snow"
11.
mark faces upwards and then return it to its
original position in the cylinder cover.
12. Fix the cylinder cover back into its original
position, and then fix all other parts back into
their proper positions.
24