PAPILLON Ranger 39 Manual De Instrucciones página 19

Ranger 39 (YD-KU03-38) & Ranger 46 (YD-KU01-45A)
35. Never cut in high
weather, when visibility is poor
or
temperatures. Always check the
tree for dead branches which
could fall during the felling
operation.
36. Keep
and free of oil or fuel mixture.
37. Operate the chain saw only in
well ventilated areas. Never start
or run the engine inside a closed
room or building. Exh- aust
fumes
carbon monoxide.
38. Do not operate the chain saw in
a tree unless specially trained to
do so.
39. Guard against kickback. Kick-
back is the upward motion of the
guide bar which occurs when
the saw chain at the nose of the
guide bar contacts an object .
Kickback can lead to dangerous
loss of control of the chain saw .
40. When transporting your chain
saw, make sure the appropriate
guide bar scabbard is in place .
KICKBACK SAFETY
TIONS FOR CHAIN SAW USERS
Kickback may occur when the
⚫
nose or tip of the guide bar
touches an object, or when the
wood closes in and pinches the
saw chain in the cut. Tip
contact in some cases may
cause a lightning fast reverse
reaction, kicking the guide bar
up and back towards the
operator. Pinching the saw
chain along the top of the guide
bar may push the guide bar
rapidly
operator. Enter of these rea-
ction may cause you to lose
control of the saw, Which could
result
injury.
wind, bad
in very high
the handles dry, Clean
contain dangerous
PRECAU-
WARNING
back towards
in serious
or low
the
personal
19
Do not rely exclusively on the
⚫
safety devices built into your
saw. As a chain saw user you
should take several steps to
keep cutting jobs free from
accident or injury.
(8) With a basic understanding of
kickback you can reduce or
eliminate the element of surp-
rise. Sudden surprise contribu-
tes to accidents.
(9) Keep a good grip on the saw
with both hands on the rear
handle, and the left hand on
the front handle, when the
engine is running . Use a firm
grip with thumbs and fingers
encircling the chain saw hand-
les. A firm grip will help you
reduce kickback and maintain
control of the saw.
(10) Make certain that the area in
which you are cutting is free
from obstructions. Do not let
the nose of the guide bar
contact a log, branch, or any
other obstruction, which could
be hit while you are operating
the saw.
(11) Cut at high engine speeds.
(12) Do not overreach or cut above
shoulder height.
(13) Follow the manufacturer's sha-
rpening and maintenance inst-
ructions for the saw chain .
(14) Only use replacement bars
and chains specified by the
manufacturer of the equivalent